Model Number

HJG-4

HJG-4 film dryer SERIES
Remote Infrared Ray Automatism
Constant Temperature Film Dry Oven

1. Brief Introduction

    HJG-4 Remote infrared ray automatism constant temperature film dry is our company promotes a new product for nondestructive testing and medical treatment service. This oven is made by accepting the newest experience exterior and interior of China.
This dry oven is vertical structure with transparent glass on top. The box uses high quality black sheet, spurting model exterior, and all spare parts are treated by galvanization anticorrosive treatment, and durable. This oven uses remote infrared ray to heat up; compare to other dry oven, it has fast increase temperature, long constant temperature, running on little electricity, reliable of insulating ability, safety use, and a long life-lived etc. advantages. It is absolutely useful equipment, especially for photograph of industrial nondestructive testing, and medical photograph for film to dry fast.

1. Specification target

Working power: 220V±15%HZ
Working temperature: 50℃
Heater power: 2000W
Engine power: 45W
Workroom size: 550X390X360(mm)
Figure size: 550X450X850(mm) (length×width×height)
Weight: 40kg

1. Method of application
   1. Operate the panel switch, increasing indication light, blast electric motor revolution, and increasing temperature. When the temperature reaches the given index number, blast electric motor runs as usual. When it leaves factory, it already adjust to 50℃. Increasing temperature indicator is off and constant temperature indicator is on. When the temperature is lower than given index number, increasing temperature indicator is on and the constant temperature indicator is off. If the circulation works, the product is qualified.
   2. Connection power, the earth foot of three pistils power sources must be well connected.
   3. There are three slots to put the frame which developing film clamps; in order to adapt to nondestructive testing for all developing film clamps. Like the large clamp or medical clamp, we can take off two slots in the middle.
   4. Dry the film in the clamps, put in back to the clamp shelf and close the oven
   5. Switch off the panel and cut off the power after you finish it.
2. Attentions
   1. Switch off the power before you take or put the film.
   2. The oven shall be placed on dry and ventilated place.